Bonjour,
Je me permet de rejoindre cet échange, car j'ai le même problème, après la mise à jour en suivant la procédure indiquée sur le site Bushnell, : plus d'écran, plus d’accès à la carte mémoire par mon ordi, seule la lampe de détection rouge clignote en set up.
Y a t il une solution ?

ci dessous la procédure buschnell
2017 TROPHY CAM AGGRESSOR
Please read the below instructions completely before starting. Failure to follow the directions will result in a bricked camera that will no longer operate and is irreversible.
Insert an SD card into the computer. If any files exist on the SD card, it is recommended to back up the files and format the card
Copy the “.BRN” and “.ena” files to an empty SD card.
Safely remove/eject the SD card from the computer once the files have been copied.
With the camera turned OFF, put the SD card and 8 fresh batteries into the camera.
Press and hold the ▲ button.
While holding the ▲ button, slide the power switch to SETUP.
A green LED (on the front of the camera) will begin flashing and you can release the ▲ button. The green LED is located in the same location as the Red PIR indicating LED, which will flash as well when motion is detected.
When the Green LED stops flashing, the update is complete.
Turn the camera off, let sit for 5-10 seconds, and then turn back to setup.

You can now setup the camera as normal, but will now have the option to change the camera from dynamic video capture to 5-60 second video clips.

merci